The Divine range of water distillers are excellently designed, well built and durable. This model is ideal for small to medium families that want pure, quality water. Independent Laboratory testing
proves that technologically advanced water distillers such as Divine are
effective at removing greater than 99.8% of all contaminants.
Features include:
Automatic fill and shutoff
Distills 16 litres in 24 hours*
16 litre holding tank
Pre-carbon filter (up to 18 months use)
Post-carbon filter (up to 3 months use)
Easy installation and operation
Minimal maintenance
Extra tap connectors for any household
1 Year electrical parts and labour warranty
10 Year limited warranty on all stainless steel parts
*Based
on 24 hours of continuous operation under ideal conditions. Actual production
may vary.
Pre Carbon Filter
The Divine units come with a pre-carbon
filter that removes VOC [Volatile Organic Chemicals] before the water
is channeled to the boiling chamber for distillation. The manufacturer of the Divine distillers recommends that
chemicals be removed by pre-carbon filter (first one supplied) before
boiling as boiling the chemicals in the water will created volatile gas
and it will vaporized. In an enclosed room such volatile gas will stay
in the room and breathing the gas is believed to be detrimental to our
health and hence the recommendation to remove them through pre-carbon
filter before distillation. Changing one pre-carbon filter is
very economical as each filter should last you between 12 and 18 months.
Post Carbon Filter
At the final stage of the water purification
process, there is a post carbon filter of coconut charcoal. Some contaminants such as sulphates, some pesticides, PCB's, etc. are vaporized with the steam and are still present in plain distilled water. The post carbon coconut charcoal filter is specifically designed to remove these contaminants giving you the purest water possible. Coconut charcoal filters last between 2 and 3 months depended on usage. Replacement cartridges can be purchased as any time.
The Divine distillers boast of a simple and practical modern
design where it has no mechanical floats and no float seals. Other old
fashion design automatic water distillers that have these mechanical floats
and float seals often are the cause of distillers to leak, fail or create
problems. Detection of water level in the boiling chamber and holding
tank is done by sensors, thereby eliminating the possible failures of
floats, seals mechanical switches that are common in many automatic distillers.
Further there is plenty of room for easy access to the electrical connectors
thereby servicing the water distiller could not be simpler. The Divine
comes complete with the stainless steel boiling chamber on the top, and
the stainless steel storage tank below for the purified water, and is
virtually assembled.
Installation is as easy as three steps:
Attach
the faucet on the front by hand as no tools are needed.
Unscrew one screw at the back of the unit to attach the pre-carbon
filter and slot in the post-carbon filter that sits on top
of the storage tank.
Attach an incoming water line to the distiller
with the sturdy white water tube and also tee-pipe connectors supplied.
Both the heating element and the solenoid valve are stainless steel.
As in most distillers the Divine also has a pin opening vent in the cooling
coil for volatile gases to vent. The fan for the cooling coil is protected
with a shroud to prevent the fan blade from knocking the coil during freight
of the unit.
